Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SF RED LIGHT ON

Created by: submit2fate Tan at: 10/23/2014 12:28 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/23/2014 12:28 PM	Rate (0)
submit2fate Tan Posts: 3 Rating: (0)	Hi, I am having SF red light on on CPU315 2DP. 5V & RUN green lights on. STOP did not light up. I got HELP ON EVENT 2X43 when i got into Diagnostic. 2 Remote panels: Interface Module: No error light. Please advice about "replace module", does it mean replace CPU? And, change "logical address", does it mean the small selector swtiches on the Interface Module and OIM? Or, program address (software)? Thanks
submit2fate Tan Posts: 3 Rating: (0)	Last edited by: submit2fate Tan at: 10/23/2014 1:13 PM Last edited by: submit2fate Tan at: 10/23/2014 1:13 PM
Suggestion To thank Quote Answer

10/31/2014 11:43 AM	Rate (0)
allmächt! Posts: 215 Rating: (6)	Hi, is it possible to send a screenshot before you go on exchanging modules? If the CPU is shown as cause of fault you should exchange it and see what happens to the fault. Did you use corresponding Hardware addresses in your program? Regards
allmächt! Posts: 215 Rating: (6)
Suggestion To thank Quote Answer

11/12/2014 7:52 AM	Rate (0)
nandgate Posts: 319 Rating: (9)	Dear submit2fate, Can you post a screen shot of the diagnostic buffer sceeen ? With regards, nandgate.
nandgate Posts: 319 Rating: (9)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on