Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Shut down 840D with PCU50 on windows XP

Created by: Mickjag at: 4/5/2006 3:42 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/5/2006 3:42 PM	Rate (0)
Mickjag Posts: 1 Rating: (0)	Cansome one say me, how it's possible to change the function associated to the "power off" on 840D. actually from HMI side (by selecting "QUIT"), when we want to stop the 840D, the result is a shut down . What we want is a restart because the operator don't have the permission to open the CNC and disconnect/reconnect the 24 Volt plug .[:(]
Mickjag Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

4/10/2006 10:21 PM	Rate (0)
SteveA Posts: 297 Rating: (41)	It is possible to get a RESTART button, but the conditions may not be acceptable. First, you need the latest HMI, at least 6.4.21. Second, the control must be at the Manufacturer password level. With this, the following section from the 10/2005 doc on cd (page IM4/2-76 from SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition) applies: Requesting a RESTART after shutdown (for Windows XP only) This function enables HMI Advanced (including Windows XP) to be shut down followed by a reboot of the PCU during the setup phase. This enables you to avoid switching the PCU or machine on and off. The following settings are required: [Miscellaneous] EnableRebootDialog=True The entry can be set either directly in the INI file or by means of the user interface via Start-up → HMI → Settings → HMI Exit Mode. If the “EXIT” menu is configured accordingly, the “Shutdown... " or "Restart ... " prompt appears depending on the access stage. • If the protection level is lower than the manufacturer level (protection level 2 to 7) or if the above entry is set to "False" in the REGIE.INI file, the prompt can be confirmed with: OK HMI is closed and Windows XP is shutdown. Cancel HMI is not closed • If you have the applicable access authorizations (protection level 2 to 7), the following option is offered: Restart HMI and Windows XP are closed and then restarted. Exit HMI is closed and Windows XP is shutdown. Cancel HMI is not closed Maybe the next update will allow a configurable password level for the restart function.
SteveA Posts: 297 Rating: (41)
Suggestion To thank Quote Answer

7/22/2013 1:04 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 3/23/2023 Posts: 4099 Rating: (192)	new question split to seperate thread with the subjectpressing "EXIT" button in HMI, machine goes to Windows and not shutdown Bestregards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on