Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Siemens S71500 and S71200 Communication to Wonderware V11

Created by: Reymond at: 6/14/2015 1:21 PM (2 Replies)

Rating (1)

Thanks 0

3 Entries

6/14/2015 1:21 PM	Rate (0)
Reymond Posts: 112 Rating: (0)	Dear Sirs/Mam, Good day may I inquire if New Siemens S71500 is compatible to Wonderware V11. Please confirm as I have new project that is in the middle of hardware selection between S7300 and S71500 serie of PLC. Best regards, Reymond
Reymond Posts: 112 Rating: (0)
Suggestion To thank Quote Answer

6/14/2015 1:42 PM	Rate (1)
MicroMan Platinum Member Joined: 11/29/2011 Last visit: 8/24/2023 Posts: 1347 Rating: (228)	Hi, I found thread about the same question: S7-1200 to Wonderware InTouch SCADA I hope I could help!
	- What you read here, please check with manuals and your requirements. - Do not forget to Test, Test and Test... - If the post is helpful, please RATE it! MicroMan
Suggestion To thank Quote Answer

6/29/2015 7:30 AM	Rate (0)
DJ_1 Gold Member Joined: 2/27/2014 Last visit: 9/21/2023 Posts: 689 Rating: (196)	Dear , Best way to establish communication between S7 1500/S7 1200 with Wonderware SCADA is Modbus TCP communication. It works fine. Regards, Dj
	With Best Regards, DJ TIA Portal - Your Gateway to automation in the Digital enterprise If you feel this post is useful then don't forget to rate it
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on