Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SIMATIC HMI KTP700F Mobile, article number 6AV2125-2GB23-0AX0

Created by: kaak elbg at: 2/3/2016 9:42 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

2/3/2016 9:42 AM	Rate (0)
kaak elbg Advanced Member Joined: 10/28/2008 Last visit: 12/2/2024 Posts: 27 Rating: (5)	New SIMATIC HMI KTP700F Mobile, article number 6AV2125-2GB23-0AX0 Panel 2nd generation is not compatible with the old one. The emergency stop button has only 2 contacts hard wired and i need the 3 contacts to locate the emergency stop for the alarm tekst. Only with a falesafe plc these contacts are visible in the plc and we do not use a fale-safe plc.

Suggestion To thank Quote Answer

2/4/2016 8:14 AM	Rate (0)
MAZENJER Silver Member Joined: 8/31/2013 Last visit: 1/14/2025 Posts: 607 Rating: (41)	Please Tell us about the way you did to install the HMI. What are the softwares of Siemens you had installed in your PC?
	Warm Regards MAZENJER
Suggestion To thank Quote Answer

9/20/2017 11:38 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (174)	New question published by AutoGen_366560 is split to a separate thread with the subject Getting the message "Error occured while writing Parameters. Operation mode parameters not stored in Connection Box." when hit save. Best regards Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on