Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Simatic Manager or Administrador doesn't recognize installe software

Created by: Victor FG at: 11/27/2009 3:17 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

11/27/2009 3:17 AM	Rate (0)
Victor FG Member Joined: 4/22/2006 Last visit: 1/10/2024 Posts: 8 Rating: (0)	Hello, my Simatic administrator or manager software doesn't recongnized the installed software. I recently installed an upgrade from WinCC flexible advanced 2005 to 2008. Whe I open a project using the manager, appears the message on the screen shown in the attached picture. If I open directly the WinCC flexible I can open the HMI program for the different projects done. I don't know if I need to install the software again of not! Regards. Attachment Simatic administrator error.JPG (112 Downloads)

Suggestion To thank Quote Answer

11/27/2009 12:11 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 10/3/2024 Posts: 8744 Rating: (1168)	Dear Victor FG, Perhaps the following link might help: http://support.automation.siemens.com/WW/view/en/38797080 Or perhaps you should check compatibility: http://support.automation.siemens.com/WW/view/en/22055368 http://support.automation.siemens.com/WW/view/en/31592453 Best regards, Wizard
	Last edited by: Wizard at: 11/27/2009 12:14 PM added compatibility
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on