Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SIMOCODE PRO V

Created by: nicopoi at: 12/13/2013 3:12 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

12/13/2013 3:12 PM	Rate (0)
nicopoi Posts: 16 Rating: (0)	hello, I don't know exactly where i have to put this post so i choose this category. I have a problem with my simocode pro V. I have aproximately 80 simocode in a PCS7 application. Siemens lend me an electrical cabinet to test just one motor. The problem is,i have configure all the paramters for a SMC_DIR (direct starter) that i need but when i'm start my motor it run only few second and immediately says return feedback off.I have check all the parameters and i don't find my problem. My return feeback is connect to current state so when the motor running is state is 1. When i put the jog-on to 1 the motor start correctly. In fact the control/command in te simocode ES need 1 state and without the jog the command nly produce rise edge. So can you give me an example of a configuration of a direct starter in the soft simocode ES. I think the problem come from this. Please, I have to finish my project for the start of the years and i can't duplicate all my simocode without find te problem. Thank you in advance
nicopoi Posts: 16 Rating: (0)
Suggestion To thank

12/16/2013 12:25 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 1/13/2025 Posts: 4114 Rating: (195)	closed cause question published twice. The second thread with the subject SIMOCODE PRO V is published within the conference Industrial Controls. Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on