Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Sinamic S 120 PI controller

Created by: arta_wahyu at: 11/17/2014 8:38 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

11/17/2014 8:38 AM	Rate (0)
arta_wahyu Posts: 30 Rating: (0)	Dear Good Afternoon Now,I doing project Sinamic S 120 to operater 2 servo motor with one shaft to roll of plastic. the speed of first motor and second motor must be same so the result is good plastic rolls. There is two data that enter to analogue input at TM31.. AI0 is for voltage from PLC and AI1 is for current from SIMADIN.. how to enter the controller at starter ? please give me suggest Thank you Best Regard Arta Wahyu
arta_wahyu Posts: 30 Rating: (0)
Suggestion To thank Quote Answer

11/17/2014 2:24 PM	Rate (0)
arta_wahyu Posts: 30 Rating: (0)	for part of sinamics I used: 1. Single motor module 6SL3120-1TE21-8AA4 2. TM 31 3. CU320-2DP 4. SMC 10 5. Servo Motor 1FT6084-8AF71-4BA3-Z 6. Resolver 4 speed at TM 31 can read data analog input that represented speed but when I get ON drive and The analog change, the speed can not change but still constant like I set fristly at assume control Priority Please give me advise or suggest Thank you
arta_wahyu Posts: 30 Rating: (0)
Suggestion To thank Quote Answer

11/17/2014 3:14 PM	Rate (0)
sergino Regular Member Joined: 3/31/2011 Last visit: 10/10/2024 Posts: 20 Rating: (0)	I did not understand well the application. Can you attach a block diagram of the system with signals exchange?

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on