Sinamics Acceptance Test

To complete the acceptance test just push your emergency stop.

Or put an 1->0->1 signal on the emergency inputs of you CU (probably X120 input 7-8)

then do a copy ram to rom.

Dear all master,

I have problem with my SINAMIC 120, when want to try to change STO parameter p9659 (SI forced checking procedure timer) by downloading new project into the drive, it show alarm : 1650 (Acceptance test required (1000)).

I already make topic before with not complete information.

now is there somebody can help me how the procedure ''acceptance test required'' or how to change parameter p9659?

Kind regard

mydesemberevil

can I know whatis the solution and procedure ? because I never do this and It happen to me now, and I need to fix it ASAP

.

Best Regard

mydesemberevil

Wim Peira

To complete the acceptance test just push your emergency stop.

Or put an 1->0->1 signal on the emergency inputs of you CU (probably X120 input 7-8)

then do a copy ram to rom.

 I did what you said but I still have a fault saying:

1650: SI P1 (CU): Acceptance test required(1000)

What I changed is p9659 from 8h to 8760h (year). Acceptance test fault on the drive itself gets cleared when resetting E-Stop but this one from Control Unit I can't get sorted out.

Please help! Thank you. 

Thank you , e stop press and then reset worked well.

ravi

In parameters in the device you have to unlock the start safety commissioning, change the value and then end the safety commissioning, it's going to ask you to save to EEPROM, reset the axis error and should work

Hope this work for you