Navigation

SINAMICS CIB and CIM

Created by: Alex Zlatanovic at: 3/27/2012 7:07 PM (1 Replies)

3/27/2012 7:07 PM	Rate (0)
Alex Zlatanovic Posts: 5 Rating: (0)	Hello, I am currently working to upgrade the SINAMICS G150/S150 demo simulatorto the new CU320-2 with the CIM. I need some guidance on connection differences between the X208 connector on the CIB versues the new 48 pin connector on the CIM. The reason for this request is that the simulator does not have a power block and it cannot produce the necessary DC power and signals that may be required for the CIM to function. I would only needa circuit cross-reference for the X208 connector pins on the CIBto their corresponding connection pins located on the new CIM. Circuit details are not required simply a transfer of connections. Please review and advise at your earliest convenience. Thank you.
Alex Zlatanovic Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

3/28/2012 9:01 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 2/3/2023 Posts: 5412 Rating: (729)	Hello, please contact the customer support with your request: Tel: +49 (0) 911 895 7222 Fax: +49 (0) 911 895 7223 Support Request : http://www.siemens.com/automation/support-request
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer