Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Sinamics CU320 Warning/Error

Created by: GeorgeIS at: 7/31/2017 10:17 AM (5 Replies)

Rating (0)

Thanks 0

6 Entries

7/31/2017 10:17 AM	Rate (0)
GeorgeIS Experienced Member Joined: 5/1/2015 Last visit: 5/6/2022 Posts: 79 Rating: (0)	Hello, I'm new in configuring SINAMICS. I have a S120 Cu320-2pn and it's coming this warning : "Maintenance requirements: Error in parameterization / configuration / commissioning .... name XXXX.... _ModuleAccespoint. Can anyone help me? Thanks in advance.

Suggestion To thank Quote Answer

7/31/2017 10:21 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 1/27/2023 Posts: 21197 Rating: (2797)	Hello, check the Telegramconfiguration in HWConfig and in the drive configuration, it must be the same and it bust be the same Telegram order. Regards Christoph
	Last edited by: ChristophD at: 7/31/2017 10:22:02 AM
Suggestion To thank Quote Answer

7/31/2017 11:35 AM	Rate (0)
GeorgeIS Experienced Member Joined: 5/1/2015 Last visit: 5/6/2022 Posts: 79 Rating: (0)	And how can I show how much is the Torque (r80)? I found the parameter (r80) and also I use a telegramm but I don't know how can i configure it. Attachment Additional.PNG (40 Downloads)

Suggestion To thank Quote Answer

7/31/2017 11:45 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 1/27/2023 Posts: 21197 Rating: (2797)	Helo, below Zusatzdaten you can interconnect the r80 with the Telegram so is send to the PLC. Regards Christoph

Suggestion To thank Quote Answer

7/31/2017 1:06 PM	Rate (0)
GeorgeIS Experienced Member Joined: 5/1/2015 Last visit: 5/6/2022 Posts: 79 Rating: (0)	Hello, This one was obvious, but my problem is I cannot set any value there. I don't now why. It's blocked even online and offline.I have to anything else? For commisioning I'm using an Update for TIA V14 : Sinamics_S120_SW_V4.8_HF4

Suggestion To thank Quote Answer

7/31/2017 2:04 PM	Rate (0)
GeorgeIS Experienced Member Joined: 5/1/2015 Last visit: 5/6/2022 Posts: 79 Rating: (0)	Hello, So I found. I must go online in Parameters and there to set p2061 the right telegramm and the right bit. Only for those who are using the update.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on