Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SINAMICS DCM WITH SINAPARA_S

Created by: AutoGen_8683474 at: 10/30/2024 5:58 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

10/30/2024 5:58 AM	Rate (0)
AutoGen_8683474 Member Joined: 6/15/2022 Last visit: 11/29/2024 Posts: 22 Rating: (0)	Hello, I want to read actual fault number with Sinapara_s block from sinamics dcm drive. Is it possible to read? Because in tia portal there is no module access point number.I added Free telegram 8/8 and it has got profibus dp communication. What should I write instead of it? Thank you
	Last edited by: AutoGen_8683474 at: 10/30/2024 06:01:34 Last edited by: AutoGen_8683474 at: 10/30/2024 06:03:14
Suggestion To thank Quote Answer

10/30/2024 1:41 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 11/28/2024 Posts: 5951 Rating: (819)	Dear AutoGen_8683474, please use the system constant (example: Slave_1~Head) of the DCM in the HW configuration. For details please find the attached screenshot. Attachment DCM_HWid.png (26 Downloads)
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

11/1/2024 10:04 AM	Rate (0)
AutoGen_8683474 Member Joined: 6/15/2022 Last visit: 11/29/2024 Posts: 22 Rating: (0)	Dear Technology Team, I try do that but still I can not read the parameter.You can see from the pictures. Thank you for your answer. Attachment screenshots.zip (23 Downloads)
	Last edited by: AutoGen_8683474 at: 11/01/2024 10:06:30
Suggestion To thank Quote Answer

11/4/2024 10:14 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 11/28/2024 Posts: 5951 Rating: (819)	Dear AutoGen_8683474, please indicate the state of the FB by using the states "Busy", "Done" and "Error". Execute a Reading command and trace these bits. Pleas use AxisNo = 2. If you are using a DCM 6RA80 AxisNo = 1 is the CUD and not the Drive.
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on