Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SINAMICS G120 CU240E-2 DP BSOD

Created by: MATT.H at: 3/18/2013 3:02 PM (6 Replies)

Rating (0)

Thanks 1

7 Entries

3/18/2013 3:02 PM	Rate (0)
MATT.H Advanced Member Joined: 7/24/2012 Last visit: 4/21/2021 Posts: 4 Rating: (0)	Hi, I can't find any solution to this issue, so here goes: I've got a CU240E-2 DP and am using Starter 4.3 to go online. I have programmed my software offline and attempt to download, but the load gets to about 94%, hangs up for a few seconds, I can hear the CU reset and then my laptop gets the dreaded BSOD. I have tried this a couple of times now and the blue screen appears every time! Has anybody experienced and resloved this?? Thanks in advance

Suggestion To thank Quote Answer

3/20/2013 12:42 PM	Rate (0)
abvto Posts: 22 Rating: (1)	Hi, Which port of CU do you use for connection with Starter? Try to commission the drive with BOP-2: is it successful? Regards, Angel
abvto Posts: 22 Rating: (1)
Suggestion To thank Quote Answer

3/21/2013 10:46 AM	Rate (0)
MATT.H Advanced Member Joined: 7/24/2012 Last visit: 4/21/2021 Posts: 4 Rating: (0)	Hi Angel, Im using the USB connection and I used starter because its not a basic configuration. Tech support are suggesting it may be because I havent connected the CU to the PM before programming... Matt

Suggestion To thank Quote Answer

3/21/2013 11:28 AM	Rate (0)
abvto Posts: 22 Rating: (1)	Hi, Did you set in Set PG/PC Interface -->Access Point: Device (Starter, Scout)? Regars, Angel
abvto Posts: 22 Rating: (1)
Suggestion To thank Quote Answer

3/21/2013 11:38 AM	Rate (0)
MATT.H Advanced Member Joined: 7/24/2012 Last visit: 4/21/2021 Posts: 4 Rating: (0)	Yes, I can connect and upload and (mostly) download, but I get starter hanging up at 94% and then my laptop gets the blue screen. Matt

Suggestion To thank Quote Answer

3/21/2013 12:01 PM	Rate (0)
abvto Posts: 22 Rating: (1)	Hi, Time ago I had similar issue. By downloading unmarkSave Ram to Rom and do it when download is completed. If this not helps try to reset factory settings, then upload drive to new project, save it and try todownloadit to the drive. If this not works maybe CU is damaged. BR, Angel
abvto Posts: 22 Rating: (1)
Suggestion To thank Quote Answer

3/21/2013 3:20 PM	Rate (0)
MATT.H Advanced Member Joined: 7/24/2012 Last visit: 4/21/2021 Posts: 4 Rating: (0)	Thanks for the advice. I re-installed Starter and attached the PM to the CU and can now download successfully

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users O_Moderator

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_G

Follow us on