Sinamics S110 PN I/O

Hello,

I have a some issues whith a Sinamics S110 CU 305 PN.(6sl3 040-0ja01-0aa0)

I can ping it but, the cpu don't recognize it as PN I/O device.

RED Led: "Bus fault" on the cpu,

RED Led: "Com" on the CU305PN 

error diagnosis: inexistant configured module

FW version: 4.4

GSDML-V2.3_Siemens_Sinamics_S110-20141024.xml

Is it the latest version?

Did this version (4.4) support really  the Sinamics as PN I/O Device?

I had the same problem with  Scalance W788, and i solved it by changing the firmware 3.2 >>> 4.0 

Tks for your help

Good morning,

I'm using Siemens application example.

Link 

It's working now!

I delted the Profisafe telegram from HW-Conf

it seems the be a bad configuration. 

i have to read more to configure it (profisafe) correctly,  then i'll add it later.

Tks for your time.

PS: can you sugguest me somme documentation 

New question published by ghdt is split to a separate thread with the subject Sinamics S110, do I need the memory card for power up?.

Best regards
Min_Moderator

Problem solved.

as suggested, it was a bad config of the communication protocol.

Siemens Telegram  111 >>> ok

Profisafe >>>> Bad 

once i've made the good settings... it's a game.

if some body has a similar problem i'm avalable to help as a beginner.    

Thanks!