Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Sinamics S110 Traversing block

Created by: Parthiban.R at: 1/27/2011 5:26 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

1/27/2011 5:26 AM	Rate (0)
Parthiban.R Advanced Member Joined: 3/13/2010 Last visit: 2/8/2024 Posts: 40 Rating: (0)	Dear friends, We need some supports in S110 Servodrive by using traversing block.In starter software traversing block was not enabled.How toenablethe traversing block. Now we are in very critical position Regards, Parthiban.R

Suggestion To thank Quote Answer

1/27/2011 1:01 PM	Rate (0)
Bartosz Toczko Regular Member Joined: 6/17/2009 Last visit: 11/20/2023 Posts: 23 Rating: (1)	Hi! Have You added Basic Positioning technology in DDS configuration?
	Best regards Bartek
Suggestion To thank Quote Answer

1/27/2011 6:58 PM	Rate (0)
lio5 Posts: 95 Rating: (0)	dear friend . in the DDS ( drive configuration) you must choose ( using the check box ) the basic poitioner option .
lio5 Posts: 95 Rating: (0)
Suggestion To thank Quote Answer

1/28/2011 5:31 AM	Rate (0)
Parthiban.R Advanced Member Joined: 3/13/2010 Last visit: 2/8/2024 Posts: 40 Rating: (0)	Hi friend, Thanks for your support. Yes, I am configured basic positioner in the configuration wizard. In that basic positioner we already checked direct setpoint/MDI. It was working fine.In the MDI block if the block is enabled green indication was glow in near by MDI . But in our application we want 12 different positioning,that why we go for traversing block.We configured the traversing block but the block enabled green indication was not glow. Waiting for your valuable reply. Thank you. Regards, Parthiban.R

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on