Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Sinamics V20 fault Parameters

Created by: igor62il at: 8/14/2023 8:47 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

8/14/2023 8:47 AM	Rate (0)
igor62il Experienced Member Joined: 5/27/2012 Last visit: 6/26/2024 Posts: 177 Rating: (0)	Hello. I have Sinamics V20 inverter. Which Parameters I need setting for use any fault status in output relay DO2? I mean when inverter have fault DO2 is close contact. Thanks

Suggestion To thank Quote Answer

8/15/2023 9:44 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 1/14/2025 Posts: 5982 Rating: (823)	Hello igor62il, you can check operating instruction manual for detailed information about parameters required for DO2 configuration. https://support.industry.siemens.com/cs/ww/en/view/109811111 Attachment V20_DO_config.png (466 Downloads)
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

8/17/2023 9:50 AM	Rate (0)
igor62il Experienced Member Joined: 5/27/2012 Last visit: 6/26/2024 Posts: 177 Rating: (0)	Thanks for helping

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_V

Follow us on