Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Sinumeric 810 GA3 unable boot up

Created by: aqiel at: 4/7/2009 9:37 AM (5 Replies)

Rating (0)

Thanks 0

6 Entries

4/7/2009 9:37 AM	Rate (0)
aqiel Posts: 2 Rating: (0)	Hai every one. I have a problem with Sinumeric 810 GA. The system is unable to boot up, the screen show : ** Initializing and Testing System ** after that no respond and stop, so milling machine cannot be operated. Please help me to fix the problem.
aqiel Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

4/7/2009 9:53 AM	Rate (0)
TSH Posts: 73 Rating: (2)	Hello You could try keeping the "Eyeball" key depressed while powering up the controller. This usually puts the controller intoinitial clear mode. If this is successful press the setup end key and allow the controller to reboot on its own. Ifinitial clear mode cannot be entered and you still have the same fault I would suspect a hardware failure. Regards
TSH Posts: 73 Rating: (2)
Suggestion To thank Quote Answer

4/7/2009 4:37 PM	Rate (0)
Gebhardt Karl Platinum Expert Joined: 7/16/2006 Last visit: 1/2/2024 Posts: 1502 Rating: (176)	Hi I think the battery is low / emty. You can try to start with pressed "Eye"-Button.
	Last edited by: Gebhardt Karl at: 4/7/2009 4:39 PM Karl
Suggestion To thank Quote Answer

4/13/2009 3:19 PM	Rate (0)
aqiel Posts: 2 Rating: (0)	Allow Mr. Karl.. Thank for your reply. I still have a problem with my control Sinumeric 810 GA3.on the screen show illegal software modul : 0004, 0001, 0001, 0002, 0002. What that is mean? I have been looking for that but till now I can't find it. Please tell me what the problems is and how to fix it. By the way, Do Siemens has representative agent in Indonesia? to make more easier for me to discuss about siemens control. Thank you, I am waiting for your repply.
aqiel Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

4/15/2009 8:40 AM	Rate (0)
TSH Posts: 73 Rating: (2)	Hello It would appear that you have a hardware problem, possibly an eprom module. Indonesia is covered for Siemens service by CNC Design, please see the following link:- http://www.cncdesign.com/customersupport/index.html Regards
TSH Posts: 73 Rating: (2)
Suggestion To thank Quote Answer

4/15/2009 4:34 PM	Rate (0)
Gebhardt Karl Platinum Expert Joined: 7/16/2006 Last visit: 1/2/2024 Posts: 1502 Rating: (176)	Hi Do the Maschine works before the Alarm is comming ? (Do you have work a day before the maschine is defekt) It is a new startup of the machine ? Was the main switch from a long time ?
	Karl
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on