Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Sinumerik 802D Alarm 400015

Created by: dennisar at: 11/22/2010 3:15 PM (6 Replies)

Rating (0)

Thanks 0

7 Entries

11/22/2010 3:15 PM	Rate (0)
dennisar Posts: 10 Rating: (0)	Profibus - DP I/O fault : log addr. 9 bus addr./slot 8/7 how to resolve it?
dennisar Posts: 10 Rating: (0)
Suggestion To thank Quote Answer

11/22/2010 3:22 PM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 7/9/2024 Posts: 571 Rating: (37)	Dear Dennisar, This alarm looks like , problem in PLC. Is it new interfacing machine or other wise at present ,have you added any new logic in the machine . The alarm says that Invalid Input address is used in the PLC. Are you using 1 PP module or 2 PP moduled?
	Last edited by: Muthamizh Selvan at: 11/22/2010 3:24 PM Regards, ŠΜS
Suggestion To thank Quote Answer

11/22/2010 3:38 PM	Rate (0)
dennisar Posts: 10 Rating: (0)	thank's for your reply mr. selvan no added anything on plc,because it was in normal operation before 2 pcs pp 72/48 best regards dennisar
dennisar Posts: 10 Rating: (0)
Suggestion To thank Quote Answer

11/22/2010 7:38 PM	Rate (0)
Lisnyak Maksim Advanced Member Joined: 11/20/2009 Last visit: 7/30/2024 Posts: 11 Rating: (0)	HI. Check voltage for modules and profibus link. ifit's ok, maybe module is defective. Regards.
	Last edited by: Lisnyak Maksim at: 11/22/2010 7:45 PM
Suggestion To thank Quote Answer

11/23/2010 2:15 PM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 7/9/2024 Posts: 571 Rating: (37)	Hi, Any NC backup has been correpted in past days. Pls check the Parameter no 11240 , wheather the profibus no is correct, Check the switch setting of profibus connector , Dip switch setting in PP module. When this alarm occurs?
	Regards, ŠΜS
Suggestion To thank Quote Answer

11/24/2010 5:23 AM	Rate (0)
dennisar Posts: 10 Rating: (0)	the trouble is no. 2 pp i/o 72/48 defective all of leds indicator on module are always on many many thank's to you all regards Lailan Dennis, Jakarta,Indonesia
dennisar Posts: 10 Rating: (0)
Suggestion To thank Quote Answer

1/14/2015 4:41 PM	Rate (0)
jrojas Posts: 1 Rating: (0)	Dear mi problem is it: I have run this CNC and execute Alarm view the gif.... please help me... Attachment 2015-01-14 11.23.11.jpg (194 Downloads)
jrojas Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on