Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Sinumerik 802D

Created by: Capriconian at: 9/9/2008 11:18 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

9/9/2008 11:18 PM	Rate (0)
Capriconian Posts: 5 Rating: (0)	Dear All, I am facing a big problem in downloading parameters to Sinumerik 802D and configuring Simodrive611. It is giving me a fault E A0832. In the manual it means clock not synchronized with master. I contacted the machine manufacturer. They sent me files with extension .PLC, .ALM, .DSP, & .NCK. Now i dont have software to download all these. In fact i dont know which software i need to download these. On the operator panel, when i go to drive MD. it is giving me error "drive not configured". I have the software Simocom U. I hope some body will help me. Regards Capriconian
Capriconian Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

9/10/2008 4:36 AM	Rate (0)
A.T.A Posts: 24 Rating: (0)	Hi. In Urane CNC machine at PLC program, many DBs are hidden (at list) but they used at program How can i show they? Best regards.
A.T.A Posts: 24 Rating: (0)
Suggestion To thank Quote Answer

9/10/2008 6:45 AM	Rate (0)
sandeep reddy Posts: 92 Rating: (7)	the drive not configured message appears because your drive and 802d control or not in clock syncronous, once the alarm 832 is cleared u will be able to see the drive data. simocomu software is used for configuring drives using a simocomu cable, 1:1 cable, 9 pin cable.
sandeep reddy Posts: 92 Rating: (7)
Suggestion To thank Quote Answer

9/10/2008 10:42 AM	Rate (0)
Capriconian Posts: 5 Rating: (0)	How can i synchronize the clock? Is there any manual which can help me? Or i go online with drive and configure it from scatch. I also have one similar machine. Is there any possibility that i upload the drive configuration from there and download it here. Regards Capriconian
Capriconian Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

9/12/2008 2:42 PM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 1/22/2025 Posts: 595 Rating: (64)	Hi. Make sure that the terminating resistors are only connected at the first and at the last stations. Successes. Attachment Cable.GIF (349 Downloads)

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on