Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SINUMERIK 840D, NCU exchange

Created by: human at: 1/12/2008 3:18 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

1/12/2008 3:18 PM	Rate (0)
human Posts: 26 Rating: (3)	Sometimes it's faster to ask :) Where can I find exact info about bringing the cnc machine to work after exchange of NCU? SINUMERIK 840D NCU-BOX 13A (1P 6FC5247-0AA00-0AA2);PCU50; Win 4.0 NT Maybe someofyou know some tips and tricks about the set up procedures, parameters,HMIetc. which could be useful?
human Posts: 26 Rating: (3)
Suggestion To thank Quote Answer

1/14/2008 4:52 PM	Rate (0)
nulizhang Platinum Expert Joined: 10/17/2007 Last visit: 11/29/2023 Posts: 3734 Rating: (302)	hi, are you new for SIEMENS 840D, it seems you only changed NCU box. if it is. you would not lose anything if changing within 30 min's. pls. give more detail if you need further help. good luck!
	If you like my comments please use "Thank" bottom left or Rating Top right
Suggestion To thank Quote Answer

1/17/2008 10:16 AM	Rate (0)
human Posts: 26 Rating: (3)	Whole NCU, not NCU-box. Thanks anyway. BTW I dont belive in 30 mins. I always do it with POWER switched ON.
human Posts: 26 Rating: (3)
Suggestion To thank Quote Answer

1/17/2008 3:19 PM	Rate (0)
nulizhang Platinum Expert Joined: 10/17/2007 Last visit: 11/29/2023 Posts: 3734 Rating: (302)	,hi, for changing 840D NCU you should not with power on.you must turn off power. you didn,t say why NCU should be replaced, if it was not defective you should back up data before changing. If back up was not possible, after changing, try to make communicate NCU<-->PCU. and then if you are lucky you can find in"Services"-->Archive dir. back-uped data for NC and PLC, load them you machine will run. good luck!
	Last edited by: nulizhang at: 21.01.2008 14:49 If you like my comments please use "Thank" bottom left or Rating Top right
Suggestion To thank Quote Answer

2/11/2008 6:25 PM	Rate (0)
human Posts: 26 Rating: (3)	Thanks :) Little misunderstanding - sorry :) I was writing about battery exchange with power ON.BTW. NCdatabeforeproblemweredifferentthan backuped on HD.
human Posts: 26 Rating: (3)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on