Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Sitrans LVL200

Created by: Insttech at: 12/1/2010 3:33 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

12/1/2010 3:33 PM	Rate (0)
Insttech Posts: 1 Rating: (0)	Good day. I have a SITRANS LVL200 contactless vibration probe. I have it hooked up with a 120VAC source. There is also a DCS input in the loop. My question is, how do I know that the probe has changed state once it comes in contact with a medium. What kind of signal is my DCS looking for to know that the probe has switched state? Thank you for any help in this matter.
Insttech Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

12/2/2010 11:16 PM	Rate (0)
danw Gold Expert Joined: 3/28/2010 Last visit: 11/30/2024 Posts: 1090 Rating: (215)	What does the LVL 200 catalog spec sheet on page 2 https://www.automation.siemens.com/w1/efiles/spmirror/3867/catalogs/catalog%20sheets/sitransl_lvl200_fi01en.pdf say the output is?

Suggestion To thank Quote Answer

6/17/2015 4:30 PM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by raymond.devro is split to a separate thread with the subject Sitrans LVL200 S/E, resistor size. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on