SM 326 - 2BF01-0AB fail safe DO 10 * 2A

hi Ghaderi,

What Engineering SW do you have?

Can you provide a screenshot of your problem?

regards,

HI dear Friend :-)

I have attached screen shot from Configuration page of SM F module . 

as seen in picture the tab " Behavior after channel fault" is gray (disable).

I want change it to " passivate affected channel" . this option changes behavior of passivation in the case of

channel fault in DO module . (I think so) . if no please guide me .

best regards 

 Dear Ghaderi,

Please send me .cfg file of your hardware config.

Did you try this in offline communication.

Ghaderi

HI dear Friend :-)

I have attached screen shot from Configuration page of SM F module . 

as seen in picture the tab " Behavior after channel fault" is gray (disable).

I want change it to " passivate affected channel" . this option changes behavior of passivation in the case of

channel fault in DO module . (I think so) . if no please guide me .

best regards 

hi Ghaderi,

the changing of the parameter you mentioned, behavior after channel faults, depends on the operation mode, that is set in the properties in the first line. If there is Standard mode selected, you can not change this parameter. 

hope this helps, 

regards