Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SMC 10 resolver trouble

Created by: arta_wahyu at: 11/12/2014 5:45 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

11/12/2014 5:45 AM	Rate (0)
arta_wahyu Posts: 30 Rating: (0)	Dear, I have problem my SMC 10 resolver 4 get error F31150 and F 31115 when I connect to motor. What shoul I do to solve that? because I have already follow remedy and acknowledge still error Thank you Best Regards Arta Attachment Topology.jpg (147 Downloads)
arta_wahyu Posts: 30 Rating: (0)
Suggestion To thank Quote Answer

11/12/2014 6:15 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 10/2/2024 Posts: 22388 Rating: (3015)	Hello, which motor and encodercable do you use? Regards Christoph

Suggestion To thank Quote Answer

11/17/2014 10:07 AM	Rate (0)
arta_wahyu Posts: 30 Rating: (0)	for the motor and smc already connect.. thank you for your respond dear I want ask again , I haveSinamic S 120 to operate 2 servo motor with one shaft to roll of plastic. the speed of first motor and second motor must be same so the result is good plastic rolls. There is two data that enter to analogue input at TM31.. AI0 is for voltage from PLC and AI1 is for current from SIMADIN.. how to enter the controller at starter ? please give me suggest what should parameter I must set thank you very much
arta_wahyu Posts: 30 Rating: (0)
Suggestion To thank Quote Answer

11/17/2014 12:08 PM	Rate (0)
casajr Posts: 153 Rating: (8)	You were asked a very specific question .... Your encoder is not set up properly. Please provide the data requested.
casajr Posts: 153 Rating: (8)	Last edited by: Min_Moderator at: 11/17/2014 3:53 PM Censored abusive part of the post
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on