Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SMC10 - bridge out resolver

Created by: andil at: 8/17/2007 3:27 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

8/17/2007 3:27 AM	Rate (0)
andil Posts: 3 Rating: (0)	Hi all, Our Sinamics system has servos with multi-pole resolvers and SMC10 DriveCliq interfaces. Occasionally we need to run the system with a motor disconnected, of course this brings up an alarm for that axis that cannot be reset. On the 611A system we used to be able to plug in a bridge into the resolver connector that would fool the control module into thinking a resolver was present and allow all alarms to be reset, anyone know how to acheive the same thing on the Sinamics system ? Andy
andil Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

8/17/2007 7:22 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 10/2/2024 Posts: 22388 Rating: (3015)	Hello, which alarm occurs? Can you deactivate the SMC10 via p145? Regards Christoph

Suggestion To thank Quote Answer

8/17/2007 8:33 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 9/30/2024 Posts: 5909 Rating: (805)	Hello, or you can deactivate the whole drive with the parameter p105. Regards,
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on