Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Some questions: Stepper motor - S7-1200

Created by: sainsiw at: 8/29/2011 2:11 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

8/29/2011 2:11 PM	Rate (0)
sainsiw Posts: 2 Rating: (0)	Hi. After a lot of attemps i have some questions. Does the stepper motor and motor controller must be Siemens or may be another company? Is the first engine output ".1" and".0" connected to themotor controller to the inputs pulse and direction? I have a problem with the applied voltage,because output S7-1200 voltage is 24 but oninput of themotor drivermustbe 12V. I took advantage of voltage divider, and I do not know if this is the correct solution. Thanks for help again:-)
sainsiw Posts: 2 Rating: (0)	Last edited by: Blue Moderator at: 29.08.2011 22:23 splitted from /tf/WW/en/Posts/61790#top and renamed
Suggestion To thank Quote Answer

8/31/2011 3:07 PM	Rate (0)
Robster Gold Expert Joined: 5/28/2008 Last visit: 10/23/2024 Posts: 1343 Rating: (141)	Hi, it don't have to be Siemens Motors. You cann connect every stepper which supports pulse/direction interface. Pulse is on output 0.0, direction at 0.1 for first stepper. Second is 0.2 und 0.3. But it depends on you configuration. Voltage divider is ok. I think it is also described in CE-X7 manual. regards

Suggestion To thank Quote Answer

9/1/2011 7:39 PM	Rate (0)
Ratan Experienced Member Joined: 12/7/2010 Last visit: 10/26/2024 Posts: 94 Rating: (0)	i have used pulse o/p function for servo the output pulses are of 12V
	Last edited by: Ratan at: 9/1/2011 7:40 PM
Suggestion To thank Quote Answer

9/3/2011 5:39 AM	Rate (0)
primus 1 Posts: 45 Rating: (4)	Hello Check the attachment below p.11, the table shows the address assignment of the pulse and direction for outputs also for signal board. Tom Attachment 41737097_Motion_STEP_7_Basic_en.pdf (529 Downloads)
primus 1 Posts: 45 Rating: (4)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on