Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Spindle is not locked in cycle start mode in Machingin Centre (vc-810,810D)

Created by: Marsus at: 3/30/2013 4:37 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

3/30/2013 4:37 AM	Rate (0)
Marsus Posts: 53 Rating: (1)	Last time the machine was a fault "enable axis missing". I saw that there were no voltage in 64. So, I made a short link from 63 to 64. So, now when I press cycle start 63,64,663 all get 24 v. and referencing is also ok. But after cycle start, spindle should be locked and should protect moving with hand. But it is not locking and showing an error"c1 drive fault". So, how can I solve the problem? I had alredy readjusted the sensors. when I changed the sensors it showed a sensor alarm. after readjusting alarm goes.
Marsus Posts: 53 Rating: (1)
Suggestion To thank Quote Answer

4/5/2013 8:43 AM	Rate (0)
hardik_vmservices Regular Member Joined: 5/25/2009 Last visit: 7/3/2024 Posts: 32 Rating: (1)	if your pulse enable(dbx1.5), drive enable(dbx2.1) and all enable's is coming, then after you increase your position controll gain 32200 of spindle for more torque.

Suggestion To thank Quote Answer

4/8/2013 10:56 AM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi You have the error on the drive before or after you move the spindle by hand? Good luck Nit

Suggestion To thank Quote Answer

5/27/2013 1:17 AM	Rate (0)
chjdchh Posts: 1 Rating: (0)	hardik_vmservices if your pulse enable(dbx1.5), drive enable(dbx2.1) and all enable's is coming, then after you increase your position controll gain 32200 of spindle for more torque. Thesignaldbx1.5 shouldbeactivethefirstmeasuresystem .....
chjdchh Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on