Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Standard length of drive clique cables for motor modules

Created by: DavidBrown at: 4/24/2016 11:14 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/24/2016 11:14 AM	Rate (0)
DavidBrown Gold Member Joined: 6/29/2012 Last visit: 12/25/2023 Posts: 975 Rating: (9)	I need to divide up my drive clique topology of my motor modules on CU320-2, because I have more then 4 axes on one drive clique line while using profisafe. I should want to order some extra drive clique cables, but I should want to know the standard used lengths of the drive clique cables delivered with a motormodule. I know a motor module is always delivered with a drive clique cable long enough to connect it to the next motor module. So, what length is used for motor module of 50 mm width : 0.11 or 0.16 m? What for motor module of 100 mm with : 0.21 or 0.26 mm? In my specific case I need to go from CU320-2 to a motor module that is behind a motor module of 50 mm and a motor module of 100mm. I should want to know the most appropriate length of the cable I need.

Suggestion To thank Quote Answer

4/24/2016 11:17 AM	Rate (0)
N. Vijay Silver Member Joined: 3/17/2013 Last visit: 8/25/2024 Posts: 481 Rating: (43)	Hi It depends on MLFB of the drive Check the link below https://support.industry.siemens.com/cs/document/45634208/maximally-permissible-lengths-of-pre-assembled-drive-cliq-cables?dti=0&lc=en-WW Vijay

Suggestion To thank Quote Answer

4/24/2016 11:27 AM	Rate (0)
Navnag Platinum Member Joined: 11/21/2007 Last visit: 9/25/2024 Posts: 2325 Rating: (308)	Hello Pl find attached the available cable lengths of Drive Cliq Cables Cheers Navnag Attachment Drive_Cliq_Cables.pdf (71 Downloads)
	There is no such thing as the last bug in a program There are no stubborn bugs, There are only stubborn Debuggers.
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on