Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

STATUS WORD

Created by: GaJEnDrA D S at: 9/29/2011 4:59 AM (1 Replies)

Rating (1)

Thanks 0

2 Entries

9/29/2011 4:59 AM	Rate (0)
GaJEnDrA D S Bronze Member Joined: 8/9/2011 Last visit: 11/1/2023 Posts: 324 Rating: (19)	Dear All Bit 3--->Drive fault present Bit 11--->Converter operation is clockwise Bit 15--->Reserved for future use The Above mentioned are the bits of the Stutus word in USS Control (That we have been using) Anyone please tell me the corresponding bits of Status word of CU_240S for Profinet communication Thanks
	"Any intelligent fool can make things bigger, more complex. It takes a touch of genius -- and a lot of courage -- to move in the opposite direction.":):)
Suggestion To thank Quote Answer

9/29/2011 7:23 AM	Rate (1)
yy1 Gold Member Joined: 3/24/2009 Last visit: 7/9/2024 Posts: 535 Rating: (112)	Dear GAJENDRADS , have a look at page 350f of this document. Status Bits for Standard Status Word for MicroMaster 3 and Main Feedback Bit 0: 1 = Ready to start Bit 1: 1 = Ready to operate Bit 2: 1 = Operation enabled Bit 3: 1 = Drive fault present Bit 4: 0 = OFF2 (Coast stop command present) Bit 5: 0 = OFF3 (Quick stop command present) Bit 6: 1 = Switch-on inhibit Bit 7: 1 = Drive warning present Bit 8: 1 = Not used (always 1) Bit 9: 1 = Serial operation allowed 0 = Serial operation blocked -- local operation only Bit 10: 1 = Frequency reached 0 = Frequency not reached Bit 11 1 = Converter output is clockwise Bit 12: 1 = Converter output is counter-clockwise Bit 13-15: Reserved for future use: These bits might not always be zero Status Bits for Standard Status Word for MicroMaster 4 and Main Feedback Bit 0: 1 = Ready to start Bit 1: 1 = Ready to operate Bit 2: 1 = Operation enabled Bit 3: 1 = Drive fault present Bit 4: 0 = OFF2 (Coast stop command present) Bit 5: 0 = OFF3 (Quick stop command present) Bit 6: 1 = Switch-on inhibit Bit 7: 1 = Drive warning present Bit 8: 1 = Not used (always 1) Bit 9: 1 = Serial operation allowed 0 = Serial operation blocked -- local operation only Bit 10 1 = Frequency reached 0 = Frequency not reached Bit 11: 0= Warning: Motor current limit Bit 12: 0= Motor holding brake active Bit 13: 0= Motor overload Bit 14: 1 = Motor running direction right Bit 15: 0= Inverter overload Please also have a look at this manual. Best regards, yy1
	Last edited by: yy1 at: 9/29/2011 7:36 AM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on