Supply voltage 400->480V, 50Hz->60Hz

I guess you must have referred earlier, even then I suggest you to have a look at it, Changing the line voltage and line frequency of the SINAMICS system for the country of destination. FAQ.

Hope this helps.

 Check out image for change in the frequency for country change for drives

DavidBrown

We have commissioned a machine with Sinamics S120 (with smartline module) and with Sinamics G120. Both have the latest firmware inside.
The machine is to be shipped to the US where 480V and 60Hz is used.
At our side we had only 400V and 50Hz.
We did the parametrization as if we normally would do for a machine that will be supplied also later on with 400V and 50Hz.
Do we need to do something special to get it working in the US on 480V and 60Hz, or is this not necessary?

DavidBrown

The smartline module has no drive-clicq, so I suppose nothing has to be done for the S120.
Do I have to do something in the G120 drive?

 There is a parameter for line feed voltage, select the proper voltage. If i remember correctly, you need to do the same in S120.

PS. When you perform Commissioning from the drive via TIA, one page on the commissioning is the input line voltage selection.

Hati

 

DavidBrown

The smartline module has no drive-clicq, so I suppose nothing has to be done for the S120.
Do I have to do something in the G120 drive?

 There is a parameter for line feed voltage, select the proper voltage. If i remember correctly, you need to do the same in S120.

PS. When you perform Commissioning from the drive via TIA, one page on the commissioning is the input line voltage selection.

 The machine is already packed. What will happen if the supply voltage parameter is still set tot 400V 50 Hz and the machine is powered up with 480V 60Hz?

DavidBrown

 

Hati

 

DavidBrown

The smartline module has no drive-clicq, so I suppose nothing has to be done for the S120.
Do I have to do something in the G120 drive?

 There is a parameter for line feed voltage, select the proper voltage. If i remember correctly, you need to do the same in S120.

PS. When you perform Commissioning from the drive via TIA, one page on the commissioning is the input line voltage selection.

 The machine is already packed. What will happen if the supply voltage parameter is still set tot 400V 50 Hz and the machine is powered up with 480V 60Hz?

 The drive will give an alarm, stating that the voltage is not what is selected.