Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Technology objects

Created by: Cosic at: 2/2/2015 1:21 PM (6 Replies)

Rating (0)

Thanks 0

7 Entries

2/2/2015 1:21 PM	Rate (0)
Cosic Posts: 4 Rating: (0)	Dear all. I have a problem with technology objects. The project was created for S7-1511-1PN, and CU310PN. Problem what I encountered is attached. If you can help me, I would be grateful. Attachment S7-1511-1PNpluscu310pn.zip (91 Downloads)
Cosic Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

2/2/2015 1:26 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 10/2/2024 Posts: 22388 Rating: (3015)	Hello, which encoder is connected to the CU310 and which encoder you have configured . Is there any fault present on the CU310 in STARTER (rdy LED on CU310 red?) Regards Christoph

Suggestion To thank Quote Answer

2/2/2015 1:59 PM	Rate (0)
Cosic Posts: 4 Rating: (0)	CU310 is connected with Drive-Cliq to Siemens motor 1FK7032-5AF21-1DG0. No errors on Cu310
Cosic Posts: 4 Rating: (0)	Last edited by: Cosic at: 2/2/2015 2:00 PM
Suggestion To thank Quote Answer

2/2/2015 2:05 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 10/2/2024 Posts: 22388 Rating: (3015)	and which encoder configuration you have on the axis?

Suggestion To thank Quote Answer

2/2/2015 2:21 PM	Rate (0)
Cosic Posts: 4 Rating: (0)	Ah, sorry. I thought it was obvious. The motor has a built-in encoder. When I enter in Scout, and then go to the parameter P400 Encoder type selection -> 10000 Identify encoder Appears encoder -> [2001] 2048, 1 Vpp, A / BC / DR I hope that is now more clearly.
Cosic Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

2/2/2015 2:52 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 10/2/2024 Posts: 22388 Rating: (3015)	can you go offline an check the axis encoder settings in the Parameterview? Axis -> Dataexchange (in the TAB "Parameter View") Regards Christoph

Suggestion To thank Quote Answer

2/17/2015 11:23 AM	Rate (0)
Cosic Posts: 4 Rating: (0)	Problem resolved. I have made a mistake. For communication between PLC and Drive, I was selected a Telegram 392, but that Telegram not had a Enkoder information. When I was select a Telegram 116, all worked well. Thanks You for help
Cosic Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on