Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TESTING PROGRAM PROBE CONNECTION

Created by: SINUTRAINLP at: 1/20/2010 2:57 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

1/20/2010 2:57 AM	Rate (0)
SINUTRAINLP Posts: 4 Rating: (0)	Hi everybody! My center machine CNC used 840D control, and now I want to check probe (Z-zero setter laser) connection. Pls, Help me?
SINUTRAINLP Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

1/20/2010 4:25 AM	Rate (0)
RAM81 Silver Member Joined: 3/3/2008 Last visit: 2/20/2023 Posts: 333 Rating: (51)	hi find the attached probe details regards ram Attachment probe.pdf (136 Downloads)

Suggestion To thank Quote Answer

1/20/2010 6:17 PM	Rate (0)
SteveA Posts: 297 Rating: (41)	The Siemens Programming Manual Measuring Cycles in Doc on CD has a section on checking the probe inputs. A simple test is to check the PLC data block signals as below: PLC service display The functional test for the probe is conducted via an NC program. The measuring signal can be controlled via the diagnostics menu "PLC status". Table 8-1 Status display for measurement signal Probe Display Probe 1 deflected DB10 DB X107.0 Probe 2 deflected DB10 DB X107.1 They also have a sample NC program to verify probe operation. This is in Section 8.3 HTH, SteveA
SteveA Posts: 297 Rating: (41)
Suggestion To thank Quote Answer

4/29/2020 7:35 PM	Rate (0)
AutoGen_4416944 Posts: 1 Rating: (0)	Ciao mi puoi spiegare come hi fatto a collegare la sonda?
AutoGen_4416944 Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

4/30/2020 6:41 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (473)	Hello, I translated your question Hi can you explain me how did I connect the probe? On what controller do want to do? could you be specific with your requirement? AutoGen_4416944 Ciao mi puoi spiegare come hi fatto a collegare la sonda?
Ekalavya Posts: 2964 Rating: (473)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on