The problem with the display of data on the panel

Hi everyone!

I have a problem with the display of data (analog signal) on the panel. Tiaportal Wincc V12 does not respond to the simulator. Instead of the output analog signal appearing lattice. Day back everything works fine. What could it be?

Installed software Step7 Proffesional, WinCC Advanced

BALAKRISHNAN92

Hi ,

communication between your plc and hmi is mpi??try checking SETPG/PC Iinterface is correct

No, isn't.  Type of PG/PC interface is Pn/IE

Hi

Try this:

- restart your PLCSim, Select in the dropdownlist "PLCSIM (TCP/IP)" then Load your PLC Sim and set it into Run

- Go to your HMI Project and open the Connections editor. select the connection an look in the Parameter Screen; the Access Point has to be "S7ONLINE".

- Get to your Control Panel -> SetPG/PC Interface. Here you have to set the Accesspoint S7ONLINE to your PLCSIM (TCP/IP)

- Start Runtime of HMI and look if its work

good luck

Bye Murof

-------------------

If the Information helps you could use the Rate Button