Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TIA portal v11 data block

Created by: arecar78 at: 10/26/2011 3:37 PM (5 Replies)

Rating (1)

Thanks 2

6 Entries

10/26/2011 3:37 PM	Rate (0)
arecar78 Posts: 24 Rating: (0)	Hi to everybody! I made data block in TIA portal v11, but address is missing. On offset position there is no address just like in picture in attachement. By default is probably used simbolic addres. Where can I change addressing? Thanks Attachment 1.JPG (688 Downloads)
arecar78 Posts: 24 Rating: (0)
Suggestion To thank Quote Answer

10/26/2011 3:57 PM	Rate (0)
arecar78 Posts: 24 Rating: (0)	arecar78 Hi to everybody! I made data block in TIA portal v11, but address is missing. On offset position there is no address just like in picture in attachement. By default is probably used simbolic addres. Where can I change addressing? Thanks Problem solved by rebuilding all software!
arecar78 Posts: 24 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users O_Moderator

11/7/2011 2:53 PM	Rate (0)
ridiska Posts: 3 Rating: (0)	Hi arecar, I have the same problem. What do you mean by "rebuilding all software"? Thanks
ridiska Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

11/8/2011 2:29 PM	Rate (1)
Marcjan Platinum Member Joined: 4/22/2010 Last visit: 12/15/2022 Posts: 5697 Rating: (708)	Hello, Try compile, Edit--> compile or CTRL + B, then you can see the offset. see attached picture Regards, Marcjan Attachment offset.JPG (521 Downloads)
	Last edited by: Marcjan at: 11/8/2011 2:32 PM Problem solved? Please let us know! Please no technical questions by PM, use the forum sections for your questions.
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users William_B

11/8/2011 4:09 PM	Rate (0)
William_B Posts: 5225 Rating: (1175)	Marcjan Try compile, Edit--> compile or CTRL + B, then you can see the offset. see attached picture Thank you for that. It is something I wondered about. Your picture resolved it for me. I wondered how one should know what the address offset is of a S7-300/400 type DB. If you right click on the column title bar (shown on the attached JPG), you can select to show the address offset. This is not shown by default. Thanks again. - William B. Attachment activate column.jpg (417 Downloads)
William_B Posts: 5225 Rating: (1175)
Suggestion To thank Quote Answer

7/19/2013 1:19 PM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 9/16/2023 Posts: 2683 Rating: (135)	Follow up question splitted to as offset activate TIA PORTAL V12, can someone help me set up ..? Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on