TIA Portal

Hi expert !

I am Quyet, I have problem with WinCC Project

I had installed TIA portal package software, but I can not open HMI Project (TP900 comfort Project)  which was created by other author

There is an appeared error when I open created project

"Project" can not be open because necessary products are missing

Before you can open "Project", other products need to be installed

Thanks for your reply !

Hi,

WinCC & Step 7 are separate packages in TIA portal. If you want only 1200 to be programmed you can go with Step 7 V13 Basic. If you want to programm other PLCs like 300/400/1500/IM CPUs/Open Controllers etc.. you will need Step 7 V13 Professional. (Maintaining V13 since it is the latest version available).

With both these softwares you will get a complimentary full fledged installation of WinCC V13 Basic. With this package you will be able to crete projects for Simatic Basic 1st Gen & Basic 2nd Gen HMIs.

In your case, the project backup contains a hardware that is not available for programming in the installed softwares you have. There is a lot to know about versions of softwares you can install under specific version of TIA portal. If you are interested we shall discuss that too.

You can download a trail version of WinCC V13 SP1 comfort/advanced/professional from following link.

https://support.industry.siemens.com/cs/document/106567563/simatic-wincc-v13-sp1-trial-available-for-download?dti=0&lc=en-US

Latest cumulative one stop update is Update 7. Link is as below

https://support.industry.siemens.com/cs/document/109311724/updates-for-step-7-v13-sp1-and-wincc-v13-sp1?dti=0&lc=en-IN

Thank you...

Hi expert !

I have succeed to open Project base on your instruction

If I install TIA V13.0 (Step 7 V13.0, WinCC Basic V13.0....). How to Upgrade to TIA V13.0 SP1

Thanks for your reply !

Hi expert !

As say before with you, I have HMI Project which is created for TP900 Comfort by my friend

I had installed Trial version WinCC comfort V13.0 SP1, and I can Open this Project

Can I Open this Project if I will be install WinCC comfort V13.0/or WinCC Professional V13.0 and Upgrade this Version to WinCC comfort V13.0 SP1/or WinCC Professional V13.0 SP1

Thanks for your reply !

Hi expert !

I have CPU314C-2DP and Touch Panel TP900

Can I connect this CPU with this Panel

Thanks for your help !

New question published by doanh is split to a separate thread with the subject Cannot send data from SIWATOOL U to SIWAREX module.

Best regards
The Helping Hand