Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TIA STP7 STL FP

Created by: Per Olof at: 4/3/2014 4:13 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

4/3/2014 4:13 PM	Rate (0)
Per Olof Posts: 311 Rating: (3)	Hello, I can not get the commmand "Flank Positiv" FP to work, see picture. Is it a bug in TIA ? Does it not work in the simulator ? Regards Per Olof Attachment FP.jpg (365 Downloads)
Per Olof Posts: 311 Rating: (3)	Last edited by: Per Olof at: 4/3/2014 4:22 PM
Suggestion To thank Quote Answer

4/3/2014 4:27 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 9/28/2023 Posts: 8593 Rating: (1132)	Hello Per Olof, Are you using the same bit? Try this: A M0.0 FP M0.1 S M0.2 Best regards, Wizard

Suggestion To thank Quote Answer

4/3/2014 4:33 PM	Rate (0)
Per Olof Posts: 311 Rating: (3)	Thanks you your replay. I can not get th Edge working in either LAD, FBD or STL in TIA V12! I have only the simulator in fron of me. Have you tried the FP on the simulator ? According to the manual it should work like this: A I 1.0 FP M 1.0 = Q 4.0 And I skip the first so I would like to have it like this: FP M1.0 S M2.0 I can not eaven fore the M1.0 to be true!! Attachment FP2.jpg (145 Downloads)
Per Olof Posts: 311 Rating: (3)
Suggestion To thank Quote Answer

4/3/2014 4:37 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 9/28/2023 Posts: 8593 Rating: (1132)	Hello Per Olof, The M1.0 is a internal marker. It will be high, when it detects a positive edge of the I1.0 So try: A M0.0 FP M1.0 S M2.0 @edit: Did try to simulate, but it did not work Best regards, Wizard
	Last edited by: Wizard at: 4/3/2014 4:44 PM
Suggestion To thank Quote Answer

4/3/2014 4:48 PM	Rate (0)
Per Olof Posts: 311 Rating: (3)	Thanks! Wizard! Do you have any solution for my other STL question ?
Per Olof Posts: 311 Rating: (3)
Suggestion To thank Quote Answer

4/3/2014 5:01 PM	Rate (0)
hdhosseini Diamond Expert Joined: 1/28/2009 Last visit: 9/25/2023 Posts: 6822 Rating: (1349)	Per Olof Thanks! Wizard! Do you have any solution for my other STL question ? Hello, To be sure of your codes, initialize all memories used in OB100,for test, and check the following codes.Please note, syntax is also important. If by positive edge in M10.0, the counter value is not changing,perhaps the bug theory is confirmed. //OB1 [code] CLR A %M10.0 FP %M10.1 S %Q0.0 CU %C1 [/code] Best regards, Hamid Hosseini
	Demo Channel on Youtube
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on