Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TIA v13 TP1200 will not automatically start application

Created by: DGH at: 10/6/2014 5:58 PM (2 Replies)

Rating (2)

Thanks 4

3 Entries

10/6/2014 5:58 PM	Rate (0)
DGH Advanced Member Joined: 10/19/2008 Last visit: 1/14/2025 Posts: 18 Rating: (0)	TP1200 will not automatically start application after loading program, i have to select start on the small menu to run app, I have been using TIAv12 & no problem with it. First time using TIA v13. any ideas would be appreciated.

Suggestion To thank Quote Answer

10/6/2014 6:48 PM	Rate (2)
Ganes10 Platinum Member Joined: 8/31/2010 Last visit: 1/9/2025 Posts: 1523 Rating: (230)	DGH TP1200 will not automatically start application after loading program, i have to select start on the small menu to run app, I have been using TIAv12 & no problem with it. First time using TIA v13. any ideas would be appreciated. Hello DGH, 1. Open the "Transfer Settings" dialog with the Transfer icon. 2. Open the "Directories" tab. Check if the "Wait [sec]" is "forever" then the project does not start automatically.Only the loader is displayed when the HMI device is switched on. If this is the case, you may change the same to "0" or "1" to "5". Whereas, "0" means - The Loader is not displayed. The project is then started immediately when the HMI device is switched on. To open the Control Panel of the HMI device, configure an operating element to close Runtime in the project. "1" to "5" means - The project starts when the delay time comes to an end.
	Like it? Rate it!
Suggestion To thank Quote Answer
This contribution was helpful to 3 thankful Users 0_Einstein Mukesh77777 Sam_L

10/6/2014 8:37 PM	Rate (0)
DGH Advanced Member Joined: 10/19/2008 Last visit: 1/14/2025 Posts: 18 Rating: (0)	Simple,Thanks Ganes10

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Ganes10

|

Share this page:

Share this page on...

Follow us on