Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TIP - WinCC Unified - Automatic login

Created by: Denilson Pegaia at: 5/27/2022 12:21 PM (1 Replies)

Rating (1)

Thanks 4

2 Entries

5/27/2022 12:21 PM	Rate (1)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 1/13/2025 Posts: 4391 Rating: (1462)	Hi, For security reasons, it is necessary that there is at least one user defined in the project and that the initial access to the project simulation or Runtime is always done through a username and password. There are cases, however, that this initial login is not desired, either to simplify the tests in the development phase, or due to specific application operation conditions. In this case (as from TIA V17) it is possible to adjust the SIMATIC Runtime Manager so that there is an automatic login (i.e., without user intervention). Steps: Start SIMATIC Runtime Manager as administrator If the application is running, stop it. Go gear (SIMATIC Runtime Manager settings), Automatic login tab Check Enable automatic login, enter User name and Password as in the project. Attachment Untitled.png (1703 Downloads)
	Last edited by: Denilson Pegaia at: 05/27/2022 12:25:27 Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer
This contribution was helpful to 4 thankful Users Jen_Moderator rdoliveira Jherson Andrade T... Roy Chérrez

6/9/2023 10:33 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (174)	New question published by CPNV_PPI is split to a separate thread with the subject WinCC Unified - Automatic login. Best regards Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on