Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TO Positioning Axis, Configuration Error

Created by: AutoGen_6936150 at: 4/13/2023 10:10 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/13/2023 10:10 AM	Rate (0)
AutoGen_6936150 Joined: 3/24/2023 Last visit: 5/17/2023 Posts: 3 Rating: (0)	Hi Everyone, I am new to Technology Objects. So currently I am playing with positioning axis, after configure all the parameters. When download to project, it show the below error. MC Fatal Alarm 105: PLC_10 AXIS_SHUTTLE_AK0095: Configuration error drive. Logical address 900, HW configuration. So maybe it was something wrong with axis configuration but how do I know which parameters was wrong? Because it does not mention which parameter that cause the error.

Suggestion To thank Quote Answer

4/13/2023 10:12 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 5/26/2023 Posts: 21494 Rating: (2851)	have you check the diagnostic Buffer if there are more details to this error?

Suggestion To thank Quote Answer

4/14/2023 8:46 AM	Rate (0)
AutoGen_6936150 Joined: 3/24/2023 Last visit: 5/17/2023 Posts: 3 Rating: (0)	At the Diagnostic Buffer it shows as below MC Fatal error 105: Configuration error drive. Logical address 900, HW configuration. MC component: AXIS_SHUTTLE_AK0095, TO_DB= 369 That's all to it. How do I know which config parameters was wrong? Attachment Capture.PNG (14 Downloads)

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on