Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

topology pm340

Created by: Rafael.Ribeiro at: 10/31/2016 1:25 PM (4 Replies)

Rating (1)

Thanks 0

5 Entries

10/31/2016 1:25 PM	Rate (0)
Rafael.Ribeiro Posts: 61 Rating: (1)	Hi all, I'm having trouble to start a sinamics PM340 with a CU310-2 DP using a cf card with firmware version 4.7 for CU310-2 I fit the CU on the PM-IF on the power module, I connect the AOP30 in the X22 connector of the CU and a siemens PC adapter USB A2 in X21 to use the starter via usb. When I turn the drive on, in the AOP appears a note "Illegal DO combination : Please check" and in the Starter the warning 1320 : topology : drive object number does not exist in configuration. Via starter i followed the steps on the warning help, but my problem still persists. Any idea? Thanks in advance.
Rafael.Ribeiro Posts: 61 Rating: (1)
Suggestion To thank Quote Answer

10/31/2016 1:33 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 9/30/2023 Posts: 21753 Rating: (2901)	Hello, do you have a screen of the topology and the Error message? Which values have the p101 and p978 on the CU? Regards Christoph
	Last edited by: ChristophD at: 10/31/2016 1:35:36 PM
Suggestion To thank Quote Answer

10/31/2016 2:11 PM	Rate (0)
Rafael.Ribeiro Posts: 61 Rating: (1)	Sure. I'm attaching it. If you need more information let me know. I put ithe pictures on word because I don't know how to attach multiple files in one post on the Siemens forum, sorry about that.Thanks in advance. Attachment pictures.docx (46 Downloads)
Rafael.Ribeiro Posts: 61 Rating: (1)
Suggestion To thank Quote Answer

10/31/2016 2:15 PM	Rate (1)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 9/30/2023 Posts: 21753 Rating: (2901)	Hello, have you loaded a project on the CU? Can you expand the parameters p978 and p101 to see all values? Hav you try to reset the factory settings of the sinamics? Regards Christoph

Suggestion To thank Quote Answer

10/31/2016 2:48 PM	Rate (0)
Rafael.Ribeiro Posts: 61 Rating: (1)	Thanks to expand my mind. When you ask to me expand the parameter 101, the index 2 has a value set, on the parameter 978 was diferent. So i set the index two equal on both parameters. After that I could make a automatic configuration and the topology warning was gone. Thanks!!
Rafael.Ribeiro Posts: 61 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on