Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Touch Panel MP 277 8''

Created by: Import-User-1 at: 4/20/2011 1:57 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/20/2011 1:57 PM	Rate (0)
Import-User-1 Posts: 3609 Rating: (29)	sami_r I would appreciate if I may ask for advice. Well, I'm working in ArcelorMittal in Steel Plant. I have one Touch panel Mp 277 8''. I had damaged power supply unit, but after it repaired I have that panel in operate mode again. But, I have problem. The application software is the same like before damage, and it is OK, but it is not OK I have some kind of alarm or error that do not allow me to operate it normaly. I do not know whether I have right or not, but I'm sure that some kind of error has memoried and it keep it hold all the time. If you have some experience I would appreciate to advice me how to remove that alarm or how to delete error. Or it is necessary to download application software again. Than you !!
Import-User-1 Posts: 3609 Rating: (29)
Suggestion To thank Quote Answer

4/20/2011 3:47 PM	Rate (0)
Sandman Platinum Member Joined: 4/29/2010 Last visit: 1/20/2025 Posts: 1557 Rating: (161)	Hello, do you use a user administration in this case (login with username + password)? best regards

Suggestion To thank Quote Answer

4/21/2011 7:30 PM	Rate (0)
sami_r Posts: 3 Rating: (0)	Hello, Yes, it's right, just like that. Regards,
sami_r Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on