Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TP177B en TIA portal V11.0 + SP"

Created by: Jose Antonio at: 8/20/2012 12:44 PM (4 Replies)

Rating (0)

Thanks 1

5 Entries

8/20/2012 12:44 PM	Rate (0)
Jose Antonio Posts: 16 Rating: (0)	Hi everyone! In a TIA portal project, when a I try to add a HMI device, I can't to find the TP177B panel in the HMI library, is there any hardware update to resolve this? Thanks
Jose Antonio Posts: 16 Rating: (0)
Suggestion To thank Quote Answer

8/20/2012 1:08 PM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 1/27/2023 Posts: 8584 Rating: (1122)	Hello, I think you are using WinCC Basic. (only for Basic panels) When you want to program a TP177B you will need at least WinCC Comfort. Best regards, Wizard

Suggestion To thank Quote Answer

8/20/2012 1:14 PM	Rate (0)
Jose Antonio Posts: 16 Rating: (0)	Hi wizard Yes, you are right!. I'm using simatic WinCC Basic V11.0 + SP2, so, What software do you recommended me for the TIA Portal v11.0 + SP2? Thanks a lot for you answer!
Jose Antonio Posts: 16 Rating: (0)
Suggestion To thank Quote Answer

8/20/2012 2:16 PM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 1/27/2023 Posts: 8584 Rating: (1122)	Hello, So you will need WinCC Comfort v11. (6AV2101-0AA01-0AA5) See also this link: Delivery release SIMATIC WinCC V11 Best regards, Wizard

Suggestion To thank Quote Answer

8/20/2012 4:38 PM	Rate (0)
Jose Antonio Posts: 16 Rating: (0)	Hi wizard Thank you so much... Best regards
Jose Antonio Posts: 16 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Wizard

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Installation Options General

Follow us on