Transfer data from Hercules SW to PLC

Hi friends!

I´ve got a PLC ET200SP 1510, and i want to send a string from Hercules SW via RS232.

I configure a protocolo with XON/XOFF, and I have this issue, i show you a pics, that you can see my problem.

I send this string: 2000PD146148GL176GT52000322000811082008102800002003330000444000319010LX021

And Ii receive this:

What can it be?

Thank you in advance 

Hello,

https://support.industry.siemens.com/tf/ww/en/posts/transfer-string-via-rs232/166774/?page=0&pageSize=10

Hello,

I understand that you say, but the configuration is the same in both.

The only characters that I don´t receive is 1, 0 and 8, I am confuse

Hello,

did you try set Control to None, disabled that Xon/Xoff? Look also to instance DB where is defined value for interface type - RS-232/485. check that value in Online, this was also common problem what I know, was not enough set this in HW cfg.

Hi,

If i don't set the XON/XOFF, I can't transfer data.

I don´t understand the instance to DB

Hello,

very sry my friend, you need look to TIA help about your used instructions and chcek there what output parameters are available for chcek. Maybe NDR or DONE, ERROR and STATUS output are there, so you need check values of these parameters via conditions. All is described in TIA help. Chcek that values or give us info how you call RECV instruction and what you check. Give us again Picture of your RECV instruction (all parameters view) what you have defined there. Pls set that Xon/Xoff off now, also in Hercules SW with this test.

When I receive my string, i have not a error, and the status label is 7002, and i look this number in help, and is only that the transfer is ok.

I configure the block, like this:

%M1.0 is always on.

i have removed XON/XOFF in Tia and Hercules, and the result is the same. Whats happend with this *****.

Thank so much friends