Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Transfer from wincc flexible to MP377 touch

Created by: MillMan at: 10/27/2008 11:54 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

10/27/2008 11:54 PM	Rate (0)
MillMan Posts: 3 Rating: (0)	Hi, I am completely new to Wincc flexible and made up a little screen program with 3 i/o windows to show tags I have from my plc. I transfer the data using the serial-PPI interface. the first transfer went fine, sent all 36 files to the hmi and I saw my little screen and found a page error. I Fixed the error on Winncc but now the transfer command no longer wants to function, it compiles and then goes back to the main page. No more communication is taking place.When I tried a back transfer it says could not establish connection, check your cables, interfaces & settings. I have the transfer set to COM1, 115200 bps, enable delta transfer,password overite & write to flash. The dip switch on the PPI converter has pin 5 set so the LED lights up, they say the baud settings their don't matter and the same on the HMI. I checked the cables, reset my PC, reset the HMI and the PPI interface. What could be the problem?
MillMan Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

10/28/2008 9:23 AM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 2/2/2023 Posts: 8586 Rating: (1122)	Dear MillMan, Please have a look at this faq: http://support.automation.siemens.com/WW/view/en/23787153 Best regards, Wizard

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on