Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Trend Temperature

Created by: tony311 at: 8/27/2013 6:12 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

8/27/2013 6:12 PM	Rate (0)
tony311 Posts: 31 Rating: (0)	Hi I'm using a TP700, I'm measuring the temperature in 8 zones of a tunnel kiln, I want a single trend graph 8 temperature zones, as in the photo to attach, Y (Temperature) X (8 temperature zones) Attachment Curva Temp.jpg (306 Downloads)
tony311 Posts: 31 Rating: (0)	Last edited by: tony311 at: 3/17/2014 7:11 AM
Suggestion To thank Quote Answer

8/28/2013 12:12 PM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 1/24/2025 Posts: 4397 Rating: (1464)	Hi The TP700 Comfort has XY graphic. It should be used as preferential way. Alternativally I could also sugest: - Place Bargraphs side by side - Place "little" cicles, animating their possitions
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

8/28/2013 6:51 PM	Rate (0)
tony311 Posts: 31 Rating: (0)	How to do this with XY grafic?
tony311 Posts: 31 Rating: (0)
Suggestion To thank Quote Answer

8/29/2013 12:56 PM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 1/24/2025 Posts: 4397 Rating: (1464)	Hi, here there is a sample program. to simulate it you should insert x1/y1, press add, insert x2/y2 press add... up to 5 In real world, the manual insert should be made by PLC program/scripting. Attachment C:\Users\z0008iwv\Documents\Bluetooth Exchange Folder\Project1.zip (579 Downloads)
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

3/17/2014 7:12 AM	Rate (0)
tony311 Posts: 31 Rating: (0)	tony311 Hi I'm using a TP700, I'm measuring the temperature in 8 zones of a tunnel kiln, I want a single trend graph 8 temperature zones, as in the photo to attach, Y (Temperature) X (8 temperature zones)
tony311 Posts: 31 Rating: (0)
Suggestion To thank Quote Answer

6/30/2017 1:22 PM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (174)	New question published by EKON_1 is split to a separate thread with the subject Any ideas why the diagram is not cleared when pressing it?. Best regards Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Adv Picture Controls

Follow us on