Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

turret

Created by: Rajni at: 9/20/2013 10:13 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

9/20/2013 10:13 AM	Rate (0)
Rajni Bronze Member Joined: 12/14/2012 Last visit: 3/12/2023 Posts: 70 Rating: (2)	Sir i have one turning maschine i open its turret there is some mach. problem now its ok now it reassemble but i have one doubt there is one absolute encoder its position get change is it required to make it zero as a normal axis.If yes then what is the step for doing this turret encoder pos. setting. .Its 802 D system
	Rajni
Suggestion To thank Quote Answer

9/21/2013 7:22 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (473)	Hello, There will be mechnical markings inside the turret you need to match it properly then you can correct you error. Regards, Prakash
Ekalavya Posts: 2964 Rating: (473)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on