Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

UDT parameters for communiaction between two PN-PN CPU

Created by: YogendraK at: 2/27/2009 5:05 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

2/27/2009 5:05 AM	Rate (0)
YogendraK Silver Member Joined: 11/9/2008 Last visit: 10/25/2023 Posts: 400 Rating: (6)	Hi J_Bell, I have read all the documents of "Open Communication Wizard" i have understand how to create connection between 2 PN-PN CPU also i have studied sample project i dont understand each and every thing of UDT can u explain me or if any information availble about UDT because i thing for communiaction between two PN-PN CPU UDT parameter are quite important.Please guide me. I have similar problem. I'm watting for ur valuble reply. Regards, Yogesh G
	Last edited by: CS Moderator at: 3/2/2009 10:58 PM new subject after splitting
Suggestion To thank Quote Answer

2/27/2009 10:33 AM	Rate (0)
YogendraK Silver Member Joined: 11/9/2008 Last visit: 10/25/2023 Posts: 400 Rating: (6)	HI, I got all information of UDT parameter. Just I want know open communication wizard is also required for Commnunication B? I have run wizard for patner B ? Regards, Yogesh G

Suggestion To thank Quote Answer

3/2/2009 11:53 AM	Rate (0)
J_Bell Posts: 5822 Rating: (411)	Dear YogendraG, I have to admit, you lost me a little bit. If I understood you correctly you ask if you need the UDT on the secondary side of a PN - PN CPU connection too? If this is the case the answer is yes. You need either the UDT or the in the current version created DB also on Partner B. If the Partner B is not a PN CPU but a CP or a 3rd party device you surely do not need this UDT or DB anyway. If you have the UDT alone you have to enter the UDT into a DB which is than loaded to the PLC, without the DB, which carries the information's about the Connection, the Connection itself can not be handled. I hope I could lead you a step further. Best regards J_Bell
J_Bell Posts: 5822 Rating: (411)
Suggestion To thank Quote Answer

3/3/2009 6:38 AM	Rate (0)
YogendraK Silver Member Joined: 11/9/2008 Last visit: 10/25/2023 Posts: 400 Rating: (6)	Dear J_Bell, Thanks For ur support.Now i have understand very clearly.If any oroblem i'll come to u. Regards, Yogendra G

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on