Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

update R variable in PLC program

Created by: taerojjang at: 1/15/2008 8:02 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

1/15/2008 8:02 AM	Rate (0)
taerojjang Regular Member Joined: 8/29/2007 Last visit: 6/26/2014 Posts: 27 Rating: (0)	Hellow all. I use 802D solution line. I want to access R variable in PLC program. access meaning is reading and writing it. anyone who knowuseful method for accessing? waiting for answer ^^

Suggestion To thank Quote Answer

1/18/2008 5:19 PM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Dear Sir to read and write R parameters, you must use the interface data listed below. More information is available in DOConCD. VB12001000 = Type of variable (R Parameter)VW12001002 = NC Variable Index (R Parameter Index +1)VB12000000.0 = Start Signal MUST be reset after transferVB12000000.1 = Read (0) Write (1) VB12002000.0 = Request complete (Could be used to reset start signal)VD12003004 = Variable value (When read from NC)VB12000001 = Number of data sets to be transferedVB12003000.0 = Variable is ValidVD12001008 = Variable value (When Written to NC) Regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

8/20/2013 9:36 AM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 11/23/2023 Posts: 2683 Rating: (135)	New question was splitted to update R variable in PLC program (802C control) Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on