Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Uploading and downloading the backup in logo 0ba3

Created by: AutoGen_1004600 at: 3/16/2015 7:14 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

3/16/2015 7:14 AM	Rate (0)
AutoGen_1004600 Regular Member Joined: 3/15/2015 Last visit: 5/23/2024 Posts: 2 Rating: (0)	can any one tell me i am facing a problem of uploading and downloading the backup in logo 0ba3.i have already installed the cable driver but still i could not download... Prince Sharma ---------------------------------------------------------------------------------------------------- Split from logo soft comfort 6.1 to 7.0
	Last edited by: Min_Moderator at: 3/16/2015 9:36:33 AM New subject after splitting
Suggestion To thank Quote Answer

3/16/2015 12:47 PM	Rate (0)
Marcjan Platinum Member Joined: 4/22/2010 Last visit: 11/18/2024 Posts: 5697 Rating: (715)	Hello, what message do you get? You know you have to switch this logo to transfer mode manually? What version of Logosoft do you use/ regards, Marcjan
	Problem solved? Please let us know! Please no technical questions by PM, use the forum sections for your questions.
Suggestion To thank Quote Answer

3/16/2015 3:04 PM	Rate (0)
gim Silver Member Joined: 9/25/2008 Last visit: 11/20/2024 Posts: 84 Rating: (5)	Hello must prepare the connection from Logo! Comfort to OBA3, turn off the OBA3, send the program to OBA3 and turn ON the OBA3 Regards
	Last edited by: gim at: 3/16/2015 3:04:40 PM
Suggestion To thank Quote Answer

3/18/2015 9:01 AM	Rate (0)
Helmut_13 Posts: 2930 Rating: (432)	Hi, as I understand you want to download a program from a PC with LSC remote to a LOGO! 0BA3? If so, then this will not work. To Transfer a program from a PC with LSC (independent if local or remote) to a LOGO! 0BA3 requires to Switch LOGO! 0BA3 to the Transfer mode. THIS MUST BE DONE MANUALLY AT THE LOGO! If LOGO! 0BA3 is not in the Transfer mode you cannot download the program. If this essential for you, then you have to replace the LOGO! by another one where this is not necessary. As I remember via GSM/GPRS it is impossible to remote program LOGO! because a 11 bit protocol is not supported via GSM/GPRS. Hope this helps
Helmut_13 Posts: 2930 Rating: (432)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on