Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Use standard RS232-USB converter and connect to it the Siemens S5 cable

Created by: thohari_indo at: 9/17/2011 7:14 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

9/17/2011 7:14 AM	Rate (0)
thohari_indo Posts: 4 Rating: (0)	Ayman Elotaify Hello, You can use one of the following solutions. 1. Using Siemens PG. 2. Use Siemens S5-USB promer. 3. Use standard RS232-USB converter and connect to it the Siemens S5 cable. 4. There's non Siemens product to connect the S5 PLCs directlly to USB port. But note that this way is not supported from Siemens and it's not tested too as it's not Siemens product. And I recommend you to migrate to S7. Regards, Please give me more information about no. 3 solution. best regards Splitted from step5 communication with usb port in laptops.
thohari_indo Posts: 4 Rating: (0)	Last edited by: O_Moderator at: 9/19/2011 8:52 AM new subject after splitting
Suggestion To thank Quote Answer

9/17/2011 9:17 PM	Rate (0)
Ayman Elotaify Platinum Member Joined: 5/28/2008 Last visit: 6/6/2023 Posts: 4448 Rating: (827)	Hello, Using USB-Serial cable allow you to have a Serial port on your laptop. In this case, you can connect the S5 cable to that com port. And I would like to tell that I have tried solution # 4 with a cable from Process Informatik. http://www.process-informatik.de/produkte/pg-usb Hope this helps.
	Ayman Elotaify
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on