Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Using AK 1703 RTU as Gateway

Created by: mcavdar at: 8/29/2012 3:44 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

8/29/2012 3:44 PM	Rate (0)
mcavdar Posts: 1 Rating: (0)	Hi, I want to ask a question about the using AK 1703 ACP RTU as a gateway. In my system, there are 250 Emic RTU and 72 AK RTU's. And at the HMI Sicam 230 6.51. At this point I want to make communicate the Emics with Sicam 230 not directly but through the AK RTU's. Emics will send signals to AK RTU over the IEC-104 protocol and AK will send them to Sicam 230 with IEC-104 again. But, I have not enough experience on these issues. Can you help me, on configuration in Toolbox II to make what i want to do. (AK RTU's have CP-2010 CPU, and one SM-2556 protocol element.) (Emic's have CP-6010 CPU and SM-3499/ETTO protocol element) With Best Regards Metin Çavdar
mcavdar Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

1/4/2018 7:15 PM	Rate (0)
AutoGen_682172 Posts: 13 Rating: (0)	you can use AK1703 as a gateway, in one our station which is being used as gateway
AutoGen_682172 Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

1/31/2018 3:41 AM	Rate (0)
tuanva06 Posts: 7 Rating: (0)	I notice you, there is a recommended limit for connection of SICAM RTU. You should connect max. 10 stations to an interface. If you have 250 Emic, you should have a lot of CP-2017 and SM-2558 modules
tuanva06 Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

1/31/2018 1:55 PM	Rate (0)
focus Posts: 108 Rating: (4)	Hello, tuanva06 . Could you please tell me where did you find this limitation about max. 10 connections for one interface? Added later: I've found that maximum numbers - 100, but recommendation to use 10 connections.
focus Posts: 108 Rating: (4)	Last edited by: focus at: 1/31/2018 3:46:52 PM
Suggestion To thank Quote Answer

3/9/2018 5:36 AM	Rate (0)
Enyantrik Posts: 2 Rating: (0)	If this 1703 ACP can be a gateway, does this have Modbus TCP Slave or OPC Server so that any SCADA software can become Modbus TCP Master or OPC client to access data of connected devices to the other side of the gateway?
Enyantrik Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

3/19/2018 6:43 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (171)	New question published by fanana is split to a separate thread with the subject is it possible to use the Ethernet card on AK as OPC server ??. Best regards Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SICAM

Follow us on