Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Using Menento (Mx.x)

Created by: sam2014 at: 2/24/2016 10:52 AM (6 Replies)

Rating (0)

Thanks 2

7 Entries

2/24/2016 10:52 AM	Rate (0)
sam2014 Experienced Member Joined: 7/30/2014 Last visit: 9/14/2023 Posts: 139 Rating: (1)	Hello, In a program, mementos exist eg M10.0 command motor running, is it related to wincc, so I get 1 when I start in wincc. If so how we do it ?! Best regards

Suggestion To thank Quote Answer

2/24/2016 11:22 AM	Rate (0)
Jeff Casagrande Posts: 1529 Rating: (202)	Sorry, I'm not really sure what you are asking.
Jeff Casagrande Posts: 1529 Rating: (202)
Suggestion To thank Quote Answer

2/24/2016 11:50 AM	Rate (0)
William_B Posts: 5225 Rating: (1182)	sam2014 Hello, In a program, mementos exist eg M10.0 command motor running, is it related to wincc, so I get 1 when I start in wincc. If so how we do it ?! Best regards Hi Jeff. I think the translation would be: We have a program where a memory marker bit (example: M10.0) is used as a command to start a motor. Is it possible that this memory marker bit is activated by WinCC? It does seem to me that this memory marker bit does go TRUE when I activate the motor in WinCC. If it is possible to start the motor by this memory marker bit by WinCC - how is it done?
William_B Posts: 5225 Rating: (1182)	Last edited by: William_B at: 2/24/2016 12:08:51 PM
Suggestion To thank Quote Answer

2/24/2016 12:01 PM	Rate (0)
sam2014 Experienced Member Joined: 7/30/2014 Last visit: 9/14/2023 Posts: 139 Rating: (1)	Hello, Thnx for reply, Yes, it is exactly what i am asking. Best regards,

Suggestion To thank Quote Answer

2/24/2016 12:07 PM	Rate (0)
William_B Posts: 5225 Rating: (1182)	sam2014 Hello, Thnx for reply, Yes, it is exactly what i am asking. Best regards, Please Sam... some more information. * PLC type? * Softwares used? * WinCC - - - - HMI or SCADA? Picture / photo of the button inside "WinCC" and PLC code will be most welcome.
William_B Posts: 5225 Rating: (1182)
Suggestion To thank Quote Answer

2/24/2016 12:21 PM	Rate (0)
Jeff Casagrande Posts: 1529 Rating: (202)	My apologies, I'm usually better at this.... Yes you can Set a bit on your HMI that is tied to a Start bit in your program. Please remember to have a Stop bit also.
Jeff Casagrande Posts: 1529 Rating: (202)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users William_B

2/24/2016 12:37 PM	Rate (0)
sam2014 Experienced Member Joined: 7/30/2014 Last visit: 9/14/2023 Posts: 139 Rating: (1)	Hello, Yes i can, i found how, thnnnnnnnnnnx Best regards

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users William_B

|

Share this page:

Share this page on...

Follow us on